Instructions in the event of a power failure

or the digibox locking out

It is possible that after the power has been disconnected or otherwise interrupted that a picture/programme is not displayed. For this reason we recommend that the digibox is left in the standby mode (red light showing) when not in use.

Procedure for manually restoring the signal using the Remote Control

1. Remove and replace the power lead from the mains supply. Leave with the red light showing for 3 minutes then switch on the digibox so as the green light is showing.

2. If not operating as normal follow instructions below.

3. Press the ‘SERVICES’ button and press 4 0 1 within 10 seconds – ‘SYSTEM SET UP’ screen should be displayed and No.1 ‘PICTURE SETTINGS’ highlighted

4. Press ‘SELECT’

5. Scroll down to No.2 ‘DEFAULT TRANSPONDER’ and press ‘SELECT’

6. Change frequency number to ‘12051’, then scroll down to ‘SAVE NEW SETTINGS’ and press ‘SELECT’

7. Scroll down to No.5 ‘MANUAL TUNING’ and press ‘SELECT’

8. Scroll down to ‘FIND CHANNELS’ and press ‘SELECT’. Wait for approximately 20 seconds and then press ‘SELECT’ again

9. Scroll down to preferred channel, say ‘CNN’ and press ‘YELLOW BUTTON’, a black tick on the ‘CHANNEL SELECTED’ should be displayed, press ‘SELECT’

10. A message should be displayed ‘CHANNEL LINE-UP COMPLETE’. Ignore the invitation to press select to continue

11. Press ‘SERVICES’ button and scroll down to ‘OTHER CHANNELS’ then press ‘SELECT’

12. Scroll down to chosen channel, say ‘CNN’ and press ‘SELECT’

13. Wait for 1 minute watching ‘CNN’ while the memory in the digibox reboots. After this time you can operate as usual